iiyama TF5039AS-B1AG 50-inch 4K interactive display

Consider it for a self-service kiosk, a shop window, an interactive product finder, a ticketing point or a wayfinding totem. It is an open-frame display built to be integrated into a housing rather than hung on a wall as a finished product, and the sealed front, gloved-hand touch and through-glass sensing are aimed squarely at public use.

Yes. iiyama rates the touch layer to work through up to 6mm of glass, so a finger on the outside of a window or a protective panel registers on the display behind it. Confirm the actual thickness of your glazing first, because touch response is specified up to that figure and not beyond it.

The front face only. That is enough for dust, splashes and daily cleaning on the side the public touches, but the rear of the chassis, the cable entries and the connections are not sealed. If the display sits outdoors or in a wash-down area, the housing has to provide that protection and keep the heat moving at the same time.

Yes. iiyama lists stylus, finger and latex-gloved hand as supported touch methods, with palm rejection on. That matters in a warehouse, a kitchen, a clinical area or a cold store where staff will not take gloves off to use a screen.

The bonded PCAP layer supports 40 simultaneous touch points, so a wide interactive surface can take several people working on it together. That is double the twenty points on iiyama's all-in-one T29 meeting-room models, and is the figure to check if the screen is a shared table-top or a multi-user browse point.

Yes. iiyama lists landscape, portrait and face-up orientation for this model, so it can be recessed into a counter or a table as well as stood upright in a totem. Face-up positions collect dust and spilled liquid on the glass, so plan the cleaning routine and the drainage around it even with an IP65 front.

No. Android 11 is built in with 4GB of memory, 32GB of storage, iiSignage2 content management, EShare wireless sharing and FailOver input recovery, so a schedule runs on the display itself. Two HDMI 2.0 inputs and a DisplayPort 1.2 input are there if you would rather drive it from an external player or a PC.

The chassis is 28.6kg without its box and 35.9kg boxed, measuring 1149.4 x 670 x 64mm, with handles fitted for the lift. As an open-frame product it is designed to be built into a housing, so the enclosure has to carry the weight, hold the mounting pattern shown in the specification table and ventilate a 137W typical draw.

Yes. iiyama lists a kiosk mode on this model, alongside FailOver input recovery that switches and restores the source on its own when a signal drops, and iiSignage2 for scheduling and controlling the content remotely. Between them an unattended screen can be pointed at one application and brought back on its own rather than needing someone to walk over to it.

Size is only half of it. The 50-inch uses a VA panel rated at 5000:1 static contrast, so blacks hold up better in a dim foyer or an evening shop window. The 65-inch uses an IPS panel rated at 1200:1, which trades that contrast for a wider usable viewing angle, better suited to a screen people approach from the side. Both give 4K, 40 touch points, 435 cd/m² through the glass, IP65 at the front, face-up mounting and 2 x 10W speakers, and the 65-inch is 53.7kg against 28.6kg and draws 183W against 137W.